www.avonbar-racing.co.uk

Cylinder Heads,Rockers & Valves

Thu, 01 Jan 1970 01:00:00 +0100

Avonbar Fully Modified Turbo cylinder head 35.7mm inlet 30mm exhaust 26/28cc chambers either 9 or 11 stud bronze guides 220lb double compound valve springs

Oil Pumps

Thu, 01 Jan 1970 01:00:00 +0100

Hi-capacity, hi-pressure, quality assured. As used in all our engine conversions and kits. Not to be confused with Sureflow pumps!

Tech tip - Before fitting a new oil pump don't forget to prime or fill the oil pump with engine oil PRIOR to fitting!! Damage to the crankshaft bearings could result if the pump is not primed.

Pistons & Connecting Rods

Thu, 01 Jan 1970 01:00:00 +0100

Flywheel & Clutch

Thu, 01 Jan 1970 01:00:00 +0100

Crankshafts & Bearings

Thu, 01 Jan 1970 01:00:00 +0100

At Avonbar Racing we supply a range of Steel billet EN40B Crankshafts to suit all applications and engines sizes If unsure please email us with your requirements. We supply a range of crankshafts for every day use from direct replacement,fast road to performance.

Gaskets & Oil seals

Thu, 01 Jan 1970 01:00:00 +0100

Gaskets and Seals Wherever possible we supply Payen or O/E Rover Quality and reliability every time.

Engine Accessories & Fittings

Thu, 01 Jan 1970 01:00:00 +0100

With all our knowledge of Engines and Engine Building, we have listed the best quality items so you can be confident on reliability.

Camshafts & Cam Accessories

Thu, 01 Jan 1970 01:00:00 +0100

Camshafts, Cam Kits, Timing Gears And Cam Accessories

Avonbar Engines

Thu, 01 Jan 1970 01:00:00 +0100

We at Avonbar Racing, have been producing superb top quality bespoke engines since 1976.
Bespoke engines are an effective way of having a quality engine to suit your own special requirements. General Spec list: Our Engine work consists of the following (unless stated otherwise) - Block Fully machined and honed to size, surfaced and De-plugged,new camshaft bearings and core plugs fitted, Crankshaft Re-ground and sized Heat treated. Ni Temp or Tuftrided, Lightened Flywheel and Clutch,++++ see note below ++++ fully balanced,Pistons matched and fitted to connecting rods, The engine is built supplied with :: Camshaft of your choice, 8 followers, Heavy duty engine bearings, mains and big ends, thrusts, Hi Capacity Hi pressure Oil pump, Duplex timing chain kit, Clutch plate, Oil seals and engine gasket set to complete the build.

Our Engine stated here are less cylinder head. Please refer to cylinder head section for your choice and specification to be assembled during the build process.

PLEASE NOTE: All Engines are based on Exchange, we require a 1275 engine for a 1275. A 998 is not acceptable in exchange for a 1275 based unit.

NOTE: For engines above 100 BHP - - we strongly recommend and advise fitting a new steel flywheel and back plate as original cast flywheels can be subject to failure due to age and fatigue. Yes its an extra cost but your safety is paramount.

Come and talk to us with your requirements.